Heating and Furnace Repair in Richardson, TX

About 45% of Richardson homes heat with utility gas, according to the Census. Many of those furnaces are in older homes. Here’s what to check when the heat stops, and what to do first if you smell gas.

Before you call about your heat in Richardson

  • Thermostat. Heat mode, setpoint above room temperature.
  • Filter. A clogged filter can overheat the furnace.
  • Power and switch. If the whole house is dark, report the outage to your electric delivery company (it’s on your bill) before you call an HVAC company. Some systems wait before restarting after power returns, so give it a little time.
  • Gas smell. If you smell gas, leave the house first, then call 911 and your gas utility from outside. Don’t touch the thermostat or light switches on the way out.
  • Carbon monoxide alarm. If it sounds, get everyone outside and call 911.

Still no heat? Call 972-423-0012, 24/7.

Heating repairs common in Richardson homes

  • Heat pumps in newer homes: defrost and reversing valve issues.
  • Blower motors and capacitors.
  • Thermostat wiring after a smart thermostat install.
  • Older gas furnaces: igniters, thermocouples or flame sensors, and limit switches.
  • Venting problems on furnaces in closets and attics.

Read heat pump vs. furnace, furnace short cycling and how to prepare for winter.

Richardson homes and what their age means for your system

Richardson has two housing booms: about 44% of its homes were built before 1980, and about 21% since 2010. The Census puts the median at 1986, and about 45% of homes heat with utility gas, the highest share of the four cities in this group.

The Census counts about 47,960 homes in Richardson. Here’s how they break down by decade built:

Built Share of homes What we often find
Before 1970 About 24% Richardson’s postwar and 1960s neighborhoods. HVAC was often upgraded piece by piece over the decades.
1970s About 20% About 50 years old. Original attic ducts are common unless replaced.
1980s–1990s About 25% 30 to 45 years old; most are on a second or third system.
2000s About 11% Original systems are 15 to 25 years old, and some still use R-22.
2010 and later About 21% A newer wave of homes and townhomes, mostly on R-410A or newer equipment.

The house’s age doesn’t tell you the system’s age. The data plate on the outdoor unit does, and it’s the first thing we read.

In Richardson’s 1960s and 1970s homes, the furnace is often in a hall closet or the attic, and the AC was added or upgraded later. In the newer homes and townhomes, the equipment is often compact and tucked into tight spaces. We plan for both. If you’re planning a bigger project around a new system, Richardson’s Home Improvement Incentive Program offers an economic incentive to homeowners who substantially reinvest in their home. Ask the City whether your project qualifies.

Richardson permits for HVAC work

  • Richardson has adopted the 2021 International Codes. Building Inspection: 2360 Campbell Creek Blvd., Suite 550, 972-744-4180.
  • The City of Richardson lets registered contractors buy permits online for mechanical repairs or replacements. Most of these permits require a licensed contractor to obtain the permit and do the work.
  • A contractor’s registration with the City must be current to buy permits online. The City lets you verify online that your contractor is registered.

Dallas Heating and Air Conditioning is registered with the City of Richardson as a mechanical contractor. For a replacement, we pull the permit and schedule the inspection.

Richardson has a large share of gas-heated homes, and furnaces vent combustion gases outside through a flue. A cracked or disconnected flue is a safety problem, so we look at it on every furnace call.

Refrigerant and efficiency rules that affect your decision

R-22. The EPA ended the manufacture of new R-22 equipment in 2010 and the production and import of R-22 itself on January 1, 2020. An R-22 system can keep running, but it can only be recharged with recovered or reclaimed R-22. A large leak on an R-22 unit is often the point where replacement makes more sense than repair.

SEER2. Since January 1, 2023, Department of Energy rules require new split-system central air conditioners installed in the Southeast region, which includes Texas, to meet at least 14.3 SEER2 under 45,000 Btu/h and 13.8 SEER2 at 45,000 Btu/h and up. New split heat pumps nationwide must meet 14.3 SEER2. See SEER vs. SEER2.

Heat pumps. A heat pump is also your air conditioner, so the same rules apply, and a failed heat pump can take out heating and cooling at once. See heat pump repair.

How a Richardson repair visit works

  1. You call. We answer 24/7.
  2. Safety first. On a gas furnace, we check venting, the flame and the gas connection before anything else.
  3. Diagnosis. A NATE-certified technician tests ignition, safeties, controls and airflow.
  4. Written price. Upfront written pricing before any work starts.
  5. Repair and test. We run a full heating cycle and confirm the safeties work.

Call right away if

  • A furnace that makes a loud bang when it lights
  • No heat in freezing weather, especially with vulnerable people in the house
  • Any smell of gas: leave first, then call
  • A carbon monoxide alarm: get everyone outside and call 911

Upfront written pricing before any work starts

No heating repair starts until you’ve approved a written price. It includes:

  • If the furnace or heat pump is near the end of its life, we show repair and replacement side by side.
  • Financing available.
  • What the written price covers: the diagnosis, the repair and any safety items we find.
  • Safety problems such as a cracked flue or a gas connection that isn’t right are listed on their own line.

Why homeowners call us

  • Upfront written pricing before any work starts
  • Financing available
  • Registered with the City of Richardson as a mechanical contractor
  • All major brands, including Carrier, Trane, Lennox, Rheem, American Standard, York, Daikin, Mitsubishi, Fujitsu, Amana, Bryant and Goodman
  • NATE-certified technicians
  • 24/7 service

More for Richardson: HVAC service in Richardson, AC repair in Richardson, AC installation in Richardson. See also furnace repair and heating service and HVAC maintenance and tune-ups.

Call 972-423-0012, open 24 hours.

Comprehensive HVAC Brand Expertise: Quality and Trust You Can Rely On

Throughout the years, our local HVAC repair company has amassed a wealth of experience working with a wide range of brands and their unique systems. Our highly trained technicians have hands-on expertise with several brands, such as Amana, Bryant, Carrier, Daikin, and Goodman. This extensive experience has equipped our team with the ability to master various repair techniques and maintenance practices, ensuring they can handle any issue, regardless of your system's make or model.

HVAC brands we service, including Amana, American Standard, Carrier, Bryant, Goodman, Trane, Ruud, Lennox, and Rheem

Selecting a dependable company like Dallas Heating and Air Conditioning is key to preserving your HVAC system's functionality and extending its life. Our team's extensive knowledge of various brands enables us to handle any challenge that may surface. Additionally, our focus on maintaining high levels of professionalism and customer care showcases our trustworthiness, delivering reliable, best-in-class solutions that give you confidence in our services.

FAQs

Frequently Asked Questions

What should I do if I smell gas in my Richardson home?

If you smell gas, leave the house first, then call 911 and your gas utility from outside. Don’t touch the thermostat or light switches on the way out.

Why does my furnace turn on and off over and over?

That’s short cycling. Common causes include a clogged filter, a dirty flame sensor, an overheating furnace or a thermostat problem.

Do I need a permit for an AC or furnace replacement in Richardson?

Yes. Richardson issues permits for mechanical repairs or replacements, usually to a licensed contractor whose City registration is current. We pull it.

Are you registered with the City of Richardson?

Yes. Dallas Heating and Air Conditioning is registered with the City of Richardson as a mechanical contractor.

How do you price the work?

You get upfront written pricing before any work starts. Financing available.

Are you open 24/7?

Yes. NATE-certified technicians, 24/7. Call 972-423-0012.

24/7 Emergency Service

Need Reliable HVAC Service in Dallas?

972-423-0012

Open 24 Hours

972-423-0012