AC Installation and Replacement in Addison, TX

The Town of Addison requires a permit to install or replace an AC system, and has a permit type for each kind of replacement. Here’s how a replacement works in Addison.

Replacing an AC in Addison

  • Refrigerant on the data plate.
  • Space. The new equipment has to fit the closet, pad or roof.
  • Which permit? Condenser only, coil, furnace or complete system each has its own permit type.
  • HOA rules. Check requirements for outdoor equipment.

We go over each of these on the first visit.

What we install in Addison

  • Thermostats
  • Heat pumps and air handlers
  • Complete systems
  • Condenser and coil replacements

Still deciding? Read should I repair or replace my air conditioner, heat pump installation and are smart thermostats worth it.

We install and service all major brands, including Carrier, Trane, Lennox, Rheem, American Standard, York, Daikin, Mitsubishi, Fujitsu, Amana, Bryant and Goodman.

Addison homes and what their age means for your system

Addison is mostly townhomes, condos and apartments: only about 13% of homes are detached houses. The Census puts the median at 1998, and about 46% of homes have been built since 2000.

The Census counts about 11,369 homes in Addison. Here’s how they break down by decade built:

Built Share of homes What we often find
Before 1980 About 12% Addison’s oldest homes and complexes. Equipment has been replaced, but layouts are original.
1980s About 18% About 40 years old; many condos and townhomes on a third system.
1990s About 24% Addison’s biggest decade. Most are on a second system.
2000s About 17% Original systems are 15 to 25 years old.
2010 and later About 29% Newer townhomes and apartments, mostly R-410A or newer.

The house’s age doesn’t tell you the system’s age. The data plate on the outdoor unit does, and it’s the first thing we read.

Because most Addison homes are attached, the typical HVAC setup is compact: an air handler or furnace in a closet or attic and a condenser on a pad, a balcony or a roof, sometimes shared with neighbors. Access, clearances and condensate routing drive the job, and a replacement has to fit the existing space. If you own a condo or townhome, check your HOA rules on outdoor equipment before replacing it. We can work with your HOA’s requirements.

Addison permits for HVAC work

  • Addison Service Center: 16801 Westgrove Drive, 972-450-2880.
  • All contractors must be registered with the Town before starting any project. Mechanical registration requires an HVAC license, ID and insurance, and renews every year. Tradesmen also submit a validation form for each job site.
  • The Town’s CSS portal has residential mechanical permit types for AC condensing unit replacement, evaporator coil, furnace only, duct work only, HVAC complete system and miscellaneous mechanical. Single-trade permits like an HVAC replacement can be submitted online.
  • The Town of Addison requires a permit for installing or replacing a furnace and installing or replacing an air conditioning system.

Dallas Heating and Air Conditioning is registered with the Town of Addison as a mechanical contractor. For a replacement, we pull the permit and schedule the inspection.

Addison requires a separate validation form for each scope of work on each job site, so the contractor responsible for your HVAC work is named on your permit.

Refrigerant and efficiency rules that affect your decision

R-22. The EPA ended the manufacture of new R-22 equipment in 2010 and the production and import of R-22 itself on January 1, 2020. An R-22 system can keep running, but it can only be recharged with recovered or reclaimed R-22. A large leak on an R-22 unit is often the point where replacement makes more sense than repair.

SEER2. Since January 1, 2023, Department of Energy rules require new split-system central air conditioners installed in the Southeast region, which includes Texas, to meet at least 14.3 SEER2 under 45,000 Btu/h and 13.8 SEER2 at 45,000 Btu/h and up. New split heat pumps nationwide must meet 14.3 SEER2. See SEER vs. SEER2.

New refrigerants. Under the EPA’s AIM Act rules, new home air conditioners and heat pumps are moving to refrigerants with lower global warming potential, such as R-454B and R-32. Read what the R-410A phase-out means.

How a Addison installation works

  1. Home visit. We check the equipment, ducts, electrical, attic access and the refrigerant type on the data plate.
  2. Sizing. We size the system for the house, its insulation, windows and ducts, not by copying the old label.
  3. Written options. Upfront written pricing for each option before any work starts. Financing available.
  4. Permit. We pull the Addison permit.
  5. Installation. Outdoor unit, matched coil or air handler, refrigerant lines, drains, electrical and thermostat as needed.
  6. Startup and inspection. We charge and test the system, then the Town inspects it.

When it makes sense to replace

  • You’re adding or remodeling space and the old system can’t keep up
  • The house never gets comfortable even after repairs
  • An R-22 system has a large leak
  • Your current system has failed and repair isn’t worth it

Upfront written pricing before any work starts

Every replacement starts with a written proposal. Here’s what goes in it:

  • Financing available.
  • Each equipment option is priced on its own.
  • Any duct, attic access or electrical work the Town will check is listed separately.
  • What the written proposal covers: the equipment, matched indoor coil or air handler, refrigerant lines, drain, electrical connections, thermostat, permit and inspection.

Why homeowners call us

  • All major brands, including Carrier, Trane, Lennox, Rheem, American Standard, York, Daikin, Mitsubishi, Fujitsu, Amana, Bryant and Goodman
  • Registered with the Town of Addison as a mechanical contractor
  • Financing available
  • Upfront written pricing before any work starts
  • 24/7 service
  • NATE-certified technicians

More for Addison: HVAC service in Addison, AC repair in Addison, heating repair in Addison. See also AC installation and replacement and HVAC maintenance and tune-ups.

Also nearby: AC installation in Carrollton, AC installation in Richardson, AC installation in Plano.

Call 972-423-0012, open 24 hours.

Comprehensive HVAC Brand Expertise: Quality and Trust You Can Rely On

Throughout the years, our local HVAC repair company has amassed a wealth of experience working with a wide range of brands and their unique systems. Our highly trained technicians have hands-on expertise with several brands, such as Amana, Bryant, Carrier, Daikin, and Goodman. This extensive experience has equipped our team with the ability to master various repair techniques and maintenance practices, ensuring they can handle any issue, regardless of your system's make or model.

HVAC brands we service, including Amana, American Standard, Carrier, Bryant, Goodman, Trane, Ruud, Lennox, and Rheem

Selecting a dependable company like Dallas Heating and Air Conditioning is key to preserving your HVAC system's functionality and extending its life. Our team's extensive knowledge of various brands enables us to handle any challenge that may surface. Additionally, our focus on maintaining high levels of professionalism and customer care showcases our trustworthiness, delivering reliable, best-in-class solutions that give you confidence in our services.

FAQs

Frequently Asked Questions

Do I need a permit to replace my AC in Addison?

Yes. Addison requires a permit for installing or replacing a furnace or air conditioning system, by a contractor registered with the Town. We file it in the Town’s CSS portal.

What efficiency does a new AC have to meet in Texas?

Since January 1, 2023, DOE rules require new split-system central air conditioners in the Southeast region, which includes Texas, to meet at least 14.3 SEER2 under 45,000 Btu/h and 13.8 SEER2 at 45,000 Btu/h and up.

Which brands do you install?

All major brands, including Carrier, Trane, Lennox, Rheem, American Standard, York, Daikin, Mitsubishi, Fujitsu, Amana, Bryant and Goodman.

Are you registered with the Town of Addison?

Yes. Dallas Heating and Air Conditioning is registered with the Town of Addison as a mechanical contractor.

How do you price the work?

You get upfront written pricing before any work starts. Financing available.

Are you open 24/7?

Yes. NATE-certified technicians, 24/7. Call 972-423-0012.

24/7 Emergency Service

Need Reliable HVAC Service in Dallas?

972-423-0012

Open 24 Hours

972-423-0012